CAN’s 2019 Spring Show: Seeing in a New Light

I was delighted to have two of my pieces accepted for the Cranberry Artists Network‘s Spring Show, Seeing in a New Light, that will be on display in the Cranberry Township Municipal Center at 2525 Rochester Road in Cranberry Twp, PA 16066 from March 4 through April 15, 2019.

The photo with this post shows CAN’s postcard announcing this show, annotated with little images of my two pieces:

Left: Seeing the Spirit in a Cube. Could a flat-sided cube hold the spirit of a few curves deep in its heart?!! This 18 x 22 x 23 mm sterling silver pendant with “puffy cube” black onyx bead (displayed here and in the show on an 18″ sterling silver snake chain) was made in August, 2016.

I’ll have to dig back through unfinished drafts: I really thought I’d at least started a post about it at the time, but can’t find it right now. I faced a number of serious challenges with that piece! If I can’t find a draft post to finish and publish here, I’ll try to recreate that story from my archived “troubleshooting notes” so I can tell that story here … eventually.

I did exhibit this Cube in one other show, the 2017 Annual Exhibition of the Pittsburgh Society of Artists. It did not find a new home at that show, and has been tucked away for safe-keeping ever since. And that’s not right: this cube with it’s puffy little center bead deserves to be out and about, decorating a new owner!

Right: What Is Behind Door #3 ?!! The answer to the question, shown in this little snapshot, is that you can find a moonstone back there, and it will be the owner’s choice whether to keep or to reveal that little secret when it’s worn! This 26 x 27 x 8 mm fine silver pendant with a 6 mm white moonstone cabochon (displayed in the show on an 18″ sterling silver rolo chain) was made in February, 2019, specifically to submit to be considered for this show.

This is yet another piece in my Doorways series, which I‘ve mentioned before. I made this one out of PMC Flex which in some ways is not the ideal silver metal clay formula to use for this specific layered construction. But I wanted to make a couple more of these, I had some “Flex” I’d opened for another project, and the amount left seemed like just about the right amount, so I went with it! And with a lot of wet-finishing, supplemented by some heat-fixing so the Flex would harden up enough to do just a bit of sanding in a few places, I’m happy with how it turned out.

Adding the moonstone on the back was not part of my original design but, as I worked on it, propping its little door open, the question “and what is behind that door?” kept popping into my head. I may have to explore other ways to “answer” that question in my next few Doorway pieces. But whoever ends up taking this one home will have the piece that sparked that exploration!